• Print this page
• Email a friend

Material: Unplated (unchromed) Zamak (pot metal)
Height, including 'tail' at bottom: 3-3/16"
Material thickness: 1/8"

This inset is shaped like an 'S'. It consists of:
1. Upper horizontal piece
    Length: 2-11/16"
    Height: 9/32"
2. Upper vertical piece
    Height: 1-23/32"
    Thickness: 9/32"
3. Middle horizontal piece
    Length: 2-19/32"
    Side height: 3/8"
4. Middle vertical piece
    Height: 1-3/8"
    Side width: 9/32"
5. Lower horizontal piece
    Length: 2-19/32"
    Side height: 3/8"
6. Lower vertical piece (tail)
    Length: 13/16"
    Thickness: 5/32"

Width, from one side to the other:
  Upper horizontal, upper vertical and lower vertical: 25/32"
  Middle horizontal, middle vertical and lower horizotal: 1-3/16"

There are three holes for the hinge pin to go through. They are located on the upper, middle and lower horizontal pieces and line up with each other vertically.
    Hole dia: 1/4"
    Distance from upper hole to middle hole, from top of upper
      horizontal piece to bottom of middle horizontal piece: 1-23/32"
    Distance from middle hole to lower hole, from bottom of middle
      horizontal piece to top of lower horizontal peice: 5/8"

Strike/Keeper for Round Edge Pilasters

Part Number: TP 140

$3.95 each

see more products in:
Ampco

Slide Bolt Latch, Concealed

Part Number: TP 425ME

$9.95 each

see more products in:
Metpar