Don't have an account? Create one!

Locker Hardware & Tools

Locker Lift

Part Number: PN-3399

$2.69 each

Ships via UPS/Fedex

Lift only for the PN-3309 Penco locker lift handle.

TechNotes

Enlargement

Material: chrome plated Zamak (pot metal)
Housing (PN-3388)
  Backplate
    Height
      Including tab at bottom: 3-11/16"
      Not including tab: 3-5/8"
    Width
      At top: 13/16"
      At bottom: 11/16"
  Tab
    Height: 3/8"
    Width: 5/16"
    Thickness: 5/32"
    Projection past bottom edge of backplate: 3/16"
  Mounting peg (projects out of the upper back portion of the
  backplate and receives a palnut, which helps hold the housing
  on the locker door)
    Dia: 3/16"
    Length: 1/2"
  Lift slot
    Width: 5/32"
    Height
      Not including tab at top and bottom of slot: 5/16"
      Including tabs: 1-7/8"
  Upper front moulding is bevelled on all four sides
    Width
      Where it meets the backplate: 13/16"
      At the top of the face: 11/32"
    Height
      Where it meets the backplate: 1-3/32"
      At the top of the face: 3/4"
  Lower slot tabs
    Width of both tabs and slot: 5/16"
    Thickness of each tab: 1/16"
    Height
      Where it meets the backplate: 7/16"
      At the top of the face: 9/32"
    Depth
      Including backplate: 13/16"
      Not including backplate: 5/8"
  Padlock hole
    Dia: 5/16"
    Type: Countersunk on the outside of each tab slot
Lift PN-3399
  General shape
    A straight, flat and wide handle on the front and top
    A flat plate of metal behind and perpendicular to the face
      of the handle, with a variety of curves along its bottom
      and side edges
Handle
  Width: 7/16"
  Height: 1-3/32"
  Thickness: 3/32"
  Top, which has a shape like a short wind bottle - fat at
    the bottom, where it meets the side handle, angled down to
    a narrow 'neck', which becomes the same thickness as the
    rest of the lift.
      Width
        At front, where it meets the handle: 7/16"
        At the back, where it meets the lift: 1/8"
      Length: 3/4"
      Thickness: 1/8"
Back plate - the curves on the back edge of the left create a tab
  and a fork to serve the followig purposes:
    The tab, located on the back upper part of the lift is shaped
      like a finger that is bent to a 'pointing' up position.
      When the left is pulled out it pivots downward on the forks
      (see below). This finger stops against the locker door, keeping
      the lift from pulling all of the way out of the housing
    The two-pronged forkshape, rounded at the tips, extends down and
      out of the lower section of the lift and fits onto the lockbar, becoming the pivoting point when the lift is pulled out.
        Base of finger bend to fork slot OC: 1-9/16"
Padlock hole dia: 5/16"
Palnut (PN-3390)
  Outside dia: 19/32"
  Depth: 1/4"
  Hole dia: 7/32"
  Hex
    Width: 7/16"
    Thickness: 1/64"
  Color: dark gold