Don't have an account? Create one!

Outdoor Equipment

Litter Management

Kwik-Pick Litter Grabber, 42"

Part Number: KKG42

$7.89 each

In-Stock.Ships via UPS/Fedex

You'll look forward to cleaning the grounds with this great tool for picking up litter. Exclusively from Shiffler, the KWIK-PICK Litter Picker is the perfect tool for removing litter from the ground without touching it. The self-cleaning, no-touch trash ejector and head cleaner allows for collected trash to be dropped into a garbage receptacle while you remain clean. Durable construction means no replaceable parts. A dozen case hardened nails that are 1-3/4" long create the tips for collecting litter. The strong aluminum shaft is a "back saving" 42" long because it eliminates repeated bending. Comes with a safety cap to cover the end when not in use. Picks up plastic bottles, candy wrappers and aluminum cans too! No groundskeeping department should be without the Kwik-Pick.

TechNotes

Enlargement

How it works: This device has an inner shaft with a plunger handle
  on the top end and the ejector platform, which surrounds each
  tine, on the bottom end. This inner shaft rides back and forth in
  the outer shaft, to which the pull handle, tine platform and tines
  are attached. When the plunger shaft is pressed down, it moves
  the ejector platform down and out the entire length of the tines,
  removing anything attached to them.
Overall length: 41"
Material
  Main shaft and plunger shaft: Satin aluminum
  Tines and spring on handle: Stainless steel
  Grip handle, tines housing, ejector platform
    and tines protective cap: Orange plastic
Measurements are taken starting at the top of the device,
  which is the plunger, and working down to the tines:
Plunger on inner shaft
  Thickness: 3/16"
  Diameter at top: 1-1/4"
Inner aluminum shaft
  Overall length, including ejection platform: 38"
  Dia: 5/8"
Spring
  Wire dia: 3/64"
  Coils per inch: 4.8
Finger pulls on outer shaft
  Qty: One (1) on each side of shaft
  Width of one: 3/4"
  Width from tip of one pull to tip of other: 2-1/2"
  Distance from underside of pulls to
    top of plunger handle: 4-1/4"
Main shaft
  Length: 34"
  Dia: 7/8"
Tine housing
  Width: 1-1/2"
  Depth: 1-1/2"
  Overall height
    Including ejection platform: 1"
    Not including ejection platform: 5/8"
Tines
  Qty: 12
  Exposed length: 1-11/16"
  Dia: 3/32"
  Distance between tines: 5/16" and 1/2"
Ejection platform
  Height: 3/8"
  Width: 1-1/2"
  Depth: 1-1/2"
  Dia of holes for tines to pass through: 3/16"
  Ejection platform's length of travel down tines
    when plunger is depressed: 2-1/16"
Tines cap
  Height
    Inside: 2-5/16"
    Outside: 2-3/8"
  Diameter
    Upper portion: 2-3/8"
    Lower portion: 1-19/32"
  Material thickness: 1/8"